Cascos Lifts have been manufactured in Spain since 1965.
The owner then was Carlos Cascos who gained his technical expertise working in the local factories of Volkswagen and Mercedes.
The experience gained working at these factories encouraged the high quality German standards seen in the Cascos products of today.
All of Cascos four post lifts platforms are manufactured utilising the design of a steel lintel underneath with a one-piece platform on top.
This design is testament to the high quality and long term reliability of the Cascos four post lift and is the ultimate choice for you.
Certificated to the highest Standards
Supplied Colours are in the Blue and Grey shown.
All our quoted Prices include delivery, installation and tuition to a prepared site.
This lift is supplied with rear slip plates and empty recesses at the front of the platform for your wheel aligners turnplates. If you do not have turning plates these will be available as an option.
Cascos C-445 Model Wheel Alignment Lift.
The C-445 is only one of the Cascos wheel alignment lifts.
The range includes models with longer platforms up to 5.2 metres and heavier lifting capacities up to 6.400kgs
Specifically designed for alignment
The cheapest way to produce an alignment lift is to take a standard flat platform lift and ‘build it up’ adding all the accessories on the top. This is what most manufacturers do, and is certainly a feature of Chinese lifts. The downside to this is the platforms end up being quite a distance from the floor when fully lowered and low clearance vehicles will struggle to get onto these lifts unless an extra-long run-up ramp is fitted making the lift extremely long overall to fit into the workshop.
Cascos gets over all these issues by designing and manufacturing a proper wheel alignment lift, producing a platform with "in built" recesses for the turnplates and slip plates. This approach to design gives some of the lowest minimum heights available when driving on to the lift. It also enables the shortest of run-up ramps and minimum space requirements in the workshop.
Extremely strong in design and manufacture - shown with optional underside lighting kit
Overall Dimensions & Specification.
See standard platform design with this lift
(This model does not include the built-in auxillary scissor shown)
Lifting time loaded
Overall height to top of posts
Fully installed overall width
Fully installed overall length (includes drive-on platform)
|Drive-on platform height, lift lowered||mm||180|
|Distance between posts||mm||2.780|
|Adjustable internal platform distance|
(adjustable track as standard)
|mm||740 - 990|
|Power 3-phase (available in 1 phase, see below)||kW||3.0|
|Fuse protection||Amps||16 - slow blow|
|Overall Weight when assembled||kg||1450|
Single Phase : This model is available in single phase supply, additional cost is £520.00 + vat