Cascos C-445H Four Post Wheel Alignment Lift 4.000kgs, with auxillary lift built-in.

Cascos Lifts have been manufactured in Spain since 1965.

The owner then was Carlos Cascos who gained his technical expertise working in the local factories of Volkswagen and Mercedes.

The experience gained working at these factories encouraged the high quality German standards seen in the Cascos products of today.

All of Cascos four post lifts platforms are manufactured utilising the design of a steel lintel underneath with a one-piece platform on top.

This design is testament to the high quality and long term reliability of the Cascos four post lift and is the ultimate choice for you.

Certificated to the highest Standards

Supplied Colours are in the Blue and Grey shown.

Note : 

All our quoted Prices include delivery, installation and tuition to a prepared site.

This lift is supplied with rear slip plates and empty recesses at the front of the platform for your wheel aligners turnplates. If you do not have turning plates these will be available as an option.

Cascos C-445H Model Wheel Alignment Lift, with auxillary lifting platform.

The C-445H is only one of the Cascos wheel alignment lifts.                                                           

The range includes models with longer platforms up to 5.2 metres and heavier lifting capacities up to 6.400kgs

Specifically designed for alignment
The cheapest way to produce an alignment lift is to take a standard flat platform lift and ‘build it up’ adding all the accessories on the top. This is what most manufacturers do, and is certainly a feature of Chinese lifts. The downside to this is the platforms end up being quite a distance from the floor when fully lowered and low clearance vehicles will struggle to get onto these lifts unless an extra-long run-up ramp is fitted making the lift extremely long overall to fit into the workshop.

Cascos gets over all these issues by designing and manufacturing a proper wheel alignment lift, producing a platform with "in built" recesses for the turnplates and slip plates. This approach to design gives some of the lowest minimum heights available when driving on to the lift. It also enables the shortest of run-up ramps and minimum space requirements in the workshop.

Design features:

  • Extra strength platforms with double "lintel style" beams.
  • Practically impossible to deform
  • Positively flat and low platforms
  • Double safety system, mechanical safety bar, pnuematic safety rack
  • Levelling alert light should the platforms go out of alignment
  • High quality guaranteed hydraulics, built at Cascos factory
  • Manual lowering valve in the event of power failure
  • Adjustable speed of lift for lighter loads
  • Flow regulation valve that achieves smooth operation regardless of weight
  • Thermal protection overload on drive motor
  • Safety system located on crossbars that will cut out in the event of cable breakage, cable slack, voltage drop, loss of power or underside obstruction.
  • ISO-9001 Quality Assurance Certification amongst others

Extremely strong in design and manufacture - shown with optional underside lighting kit

Overall Dimensions & Specification.

See standard platform design with this lift

(This model C-445, includes the built-in auxillary scissor shown)

Lifting Capacity
Lifting time loaded
Lifting height
Overall height to top of posts
Fully installed overall width
Fully installed overall length (includes drive-on platform)
Drive-on platform height, lift loweredmm180 
Platform width
Platform length
Distance between postsmm2.780
Adjustable internal platform distance
(adjustable track as standard)
mm740 - 990
Power 3-phase        (available in 1 phase, see below)kW3.0
Power supplyV/Hz400/50
Fuse protectionAmps16 - slow blow
Overall Weight when assembledkg1450

Dimensions of Auxillary Lifting Platform C-445H

Maximum auxillary platform lifting heightmm500
Auxillary Platform fully closed lengthmm1450
Auxillary Platform fully open length

Single Phase : This model is available in single phase supply, additional cost is £520.00 + vat