Majorlift HPJ4 / MPJ4 Manual or Air Operated Jacking Beams


The Majorlift HPJ4 & MPJ4 manual or air operated Jacking Beams, are exceptionally well designed and manufactured in the UK. All Majorlift jacking beams are available to fit your inspection pit or vehicle lift or scissors lift due to the comprehensive range of support arms and adaptors.

Available hand operated or air hydraulic they are both are suitable for cars and vans.

These jacking beams has a lifting capacity of 4.0 tonnes

It enjoys the following specification : 

  • Top Beam – 4.0 tonne model now with an extra-wide extending top beam to 1605mm.

  • Ram and Scissors – A full 205mm lift with proven hydraulics.

  • Safety Features – Hose burst and pressure release valves prevents overloading, finger guard complies with European machinery directive and CE marking.

  • Quiet Pump – New quiet design pump, built into every air jack.

  • Mechanical Lock – Engages automatically carrying out extensive wheel overhauls.

  • Raiser Blocks – Supplied as standard with each beam. Rubber-topped screw pad 1532A & aluminium block 1526, 1527 see below.

  • Support Arms – Effortless operation from quality roller bearings give easy movement.

  • Roller Hook or Roller Flat Support Arms Supplied As Standard

Massive selection of support-arms to fit your specific lift or inspection pit, at extra cost (P.O.A).

See the range of support arms for your lift : 

2.0_2.8t_support_arms.pdf


"CLICK HERE" to see this beam in action


MPJ4 4-tonne air-operated or HPJ4 4-tonne hand-operated.

A 4 tonne capacity unit that is purpose-designed for the heavyweight 4x4s. 

It has power and with optional 180mm extension tubes, the reach to cope with these high axle vehicles.



Technical Data


RATED 4 TONNES
MOT Approval for

Part No. Manual
HPJ4
Part No. Air/Hydraulic
MPJ4
A Width when extended
1605mm – 63″
B Width when retracted
864mm – 34″
C Minimum width over support arms
830mm – 32.5″
D Maximum width over support arms
1300mm – 51″
E Closed height
261mm – 10.25″
F Total lift
205mm – 8″
*G Height above platform/floor
97mm – 3.8″
*can be set lower with special arms if required

Weight – with top beam
155kgs – 341lbs

Narrow Jacking Beams to fit narrow pits and lifts (pump mounted externally)

C Minimum width over support arms
N/A
D Maximum width over support arms
N/A
OPTIONAL EXTRA WIDE TOP BEAM

A Width when extended
N/A
B Width when retracted
N/A


RAISER BLOCKS
RATED 4 TONNES
Part No.

1532A
Standard
1526
Standard
1527
Standard
1532C
Optional
1532V
Optional


Return to jacking beams