3200kgs Scissor lift. The Consul 0.32 SDE full height version


"The System makes the difference"

Consul Lifts have been manufactured in Germany since 1953.

They are manufactured to the highest quality and standards and are exceptionally strong in design. All Consul scissor lifts are low-profile so can be surface mounted without the need to recess them into the floor.

Consul 56540.8 Short Platform Scissor Lift. 

The Consul short platform, full height scissor lift is exceptionally low profile being 105mm in height when fully closed. This is a major advantage if you have a small area where you would like to fit it as no building works will be required. Being a full height model it will lift to 2 metres  high and has a massive 800mm between the platforms when raised. There are no cross beams or torsion bars between the platforms allowing simple easy access under the vehicle.

All the Consul scissor lifts are fitted with twin hydraulic rams requiring no additional safety locks and no air supplies necessary. The platforms are slip resistant as standard and the platform length of 1460mm is adjustable to 1785mm or 2110mm by locking in of the run up ramp(s). 

Can be supplied in 3-phase or single phase power supply.

Lifting Capacity 3.200kgs


Controller

800 x 300 x 300mm


Design features:

  • Platforms made from slip-resistant plate
  • Integrated electro-hydraulic drive
  • Dual hydraulic system - double cylinder in every scissor, no air supply necessary
  • Audible safety signal tone during final lowering phase
  • Dead-man control
  • Fitted emergency lowering device and overload protection
  • Adjustable in length with flap mechanism, can be operated from the side
  • Hydraulic synchronization of platform level with cylinder back-up principle
  • No mechanical linkage between the platforms
  • All hinge points are equipped with lubricating bolts
  • Base frame hot-dip galvanized and galvanized drive-on ramps
  • Includes 4 elastomer rubber adapters (20mm high)
  • In-ground installation possible without additional accessories (if required)
  • Protection class IP54, GS-approved, DIN EN 1493, CE-approved
  • Dimensions of Controller : 800 x 300 x 300mm

Specifications: 

Lifting Capacitykg3.200
Lifting heightmmapprox. 2.000
Lifting time loadedsapprox. 45
Platform lengthmmapprox. 1.460 - 2.110
Platform widthmmapprox. 565
Drive-on / over heightmmapprox. 105
Distance between platformsmmapprox. 800
PowerkW2,2
Power supply (electrical)V/Hz400 / 50
Fuse protection (electrical)A slow blow16


Options Available :Other size lift pads :Dimensions :
Part no : 32958.1

"Elastomer" Synthetic polymer rubber  blocks, 250 x 150 x 20mm to pick up on chassis points. 1 set = 4 pieces.


Part no : 26936.5
"Elastomer" Synthetic polymer rubber  blocks,
250 x 150 x 60mm to pick up on chassis points. 1 set = 4 pieces.
Part no : 32959.9
"Elastomer" Synthetic polymer rubber  blocks,
250 x 150 x 90mm to pick up on chassis points. 1 set = 4 pieces.



"Click here" to download brochure
Consul_Scissor_Lifts_Short_MGE.pdf