"The System makes the difference"
Consul Lifts have been manufactured in Germany since 1953.
They are manufactured to the highest quality and standards and are exceptionally strong in design. All Consul scissor lifts are low-profile so can be surface mounted without the need to recess them into the floor.
The Consul short platform, full height scissor lift is exceptionally low profile being 105mm in height when fully closed. This is a major advantage if you have a small area where you would like to fit it as no building works will be required. Being a full height model it will lift to 2 metres high and has a massive 800mm between the platforms when raised. There are no cross beams or torsion bars between the platforms allowing simple easy access under the vehicle.
All the Consul scissor lifts are fitted with twin hydraulic rams requiring no additional safety locks and no air supplies necessary. The platforms are slip resistant as standard and the platform length of 1460mm is adjustable to 1785mm or 2110mm by locking in of the run up ramp(s).
Can be supplied in 3-phase or single phase power supply.
Lifting Capacity 3.500kgs
800 x 300 x 300mm
|Lifting height||mm||approx. 2.000|
|Lifting time loaded||s||approx. 45|
|Platform length||mm||approx. 1.460 - 2.110|
|Platform width||mm||approx. 565|
|Drive-on / over height||mm||approx. 105|
|Distance between platforms||mm||approx. 800|
|Power supply (electrical)||V/Hz||400 / 50|
|Fuse protection (electrical)||A slow blow||16|
|Options Available :||Other size lift pads :||Dimensions :|
|Part no : 32958.1|
"Elastomer" Synthetic polymer rubber blocks, 250 x 150 x 20mm to pick up on chassis points. 1 set = 4 pieces.
|Part no : 26936.5||"Elastomer" Synthetic polymer rubber blocks,|
250 x 150 x 60mm to pick up on chassis points. 1 set = 4 pieces.
|Part no : 32959.9||"Elastomer" Synthetic polymer rubber blocks,|
250 x 150 x 90mm to pick up on chassis points. 1 set = 4 pieces.